Advertisement
Connector clip
2 Cushion tapes
TOOLS AND SUPPLIES REQUIRED
Small flat-tip screwdriver
#2 Phillips screwdriver
Eye protection (face shield, safety goggles, etc.)
Drill
5.5 mm and 12 mm Drill bits
Tape measure
File
Felt-tip pen
Pliers
17 mm Open-end wrench
10 mm and 17 mm Sockets
Electrical tape
Ratchet
Illustration of the Alarm Installed on the Vehicle
CONTROL UNIT
ALARM HARNESS
2 of 12
LED
DISARM
SWITCH
LEFT
FUSE BOX
Adjusting the Control Unit
•
Use a small flat-tip screwdriver to change the mode
switch and the horn/siren switch and to adjust
sensitivity.
GLASS
BREAKAGE
SENSOR
MIN MAX
MODE SWITCH:
•
Set the mode switch according to the customer's
choice.
•
Refer to the Owner's Manual for the explanation of
each mode.
GLASS BREAKAGE SENSOR:
Do not attach anything like scotch tape over the holes;
this is a microphone pickup.
SENSITIVITY ADJUSTMENT KNOB:
•
Adjust the sensitivity only if the customer requests it;
the sensitivity adjustment of the glass break sensor
is factory-set.
•
Be careful when you adjust the sensitivity; if you raise
the sensitivity too much, the system can give a false
alarm, and if the sensitivity is too low, the security
system may not work even if glass is broken.
AII 19610 (9810)
MODE SWITCH
AUTO LOCK
A U T O
MANUAL
SENSITIVITY
ADJUSTMENT
KNOB
© 1998 American Honda Motor Co., Inc - All Rights Reserved.
Advertisement
