K-sun BEE3-EZ Operator's Manual page 2

Federal Communications Commission (FCC) Declaration of Conformity
K-Sun® Corporation
370 SMC Drive, PO Box 309
Somerset, WI 54025
Phone: 715-247-4440
Product Name:
Model Number:
This device complies with part 15, subpart B Class B limits of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
→ →
Increase the separation between the equipment and receiver.
→ →
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
→ →
Consult the dealer or an experienced radio/TV technician for help.
→ →
To ensure compliance with the limits for a Class B digital device the enclosed interface cable should be used. (If
→ →
Applicable)
Modifications or changes not expressly approved by K-Sun® Corporation could void the user's authority to
→ →
operate the equipment.
We hereby declare that the following our product conform with the essential health and safety requirement of the Low
Voltage Directive 2006/95/EC and EMC Directive 2004/108/EC and Eco-design Directive 2009/125/EC and EU RoHS
Directive 2011/65/EU.
Product
Model
Manufacturer
The above product has been evaluated by the following European standard. The technical construction file (TCF) for
this product is retained at the above manufacturer's location.
Low Voltage Directive
Directive 2006/95/EC
EN 60950-1 (2006) + A11(2009)+ A1(2010), A12(2011)
EN 62311 (2008)
EMC Directive
Directive 2004/108/EC
EN 55022 (2010), Class B
EN 55024 (2010)
EN 61000-3-2 (2006) +A1(2009) +A2(2009)
EN 61000-3-3 (2008)
Eco-design Directive
Directive 2009/125/EC
COMMISSION REGULATION (EC) No 1275/2008
COMMISSION REGULATION (EC) No 278/2009
EU RoHS Directive
Directive 2011/65/EU
EN 50581 (2012)
2
K-Sun® LABELShop® BEE3®-EZ, BEE3®-EZ+
K-Sun® LABELShop® BEE3®-EZ, BEE3®-EZ+
EC DECLARATION OF CONFORMITY
Label Printer
LABELShop® BEE3 [BEE3®, BEE3®+,BEE3®-EZ, BEE3®-EZ+]
K-Sun® Corporation
370 SMC Drive PO Box 309 Somerset WI 54025, USA
Year of affixation of the CE Marking : 2009