GE EWA4600G0 Technical Service Manual page 20

Drain Pump
The drain pump is coupled to a 120 VAC, 60 Hz, 85
watt motor. The pump motor has an approximate
resistance value of 12 Ω.
Note: If a wash cycle has started and the customer
stops the washer by pushing in on the timer knob,
the pump will not drain any water in the tub. The
washer will go through a spin algorithm to de-
energize the mode shifter and shut down. The water
stays in the tub.
To remove the pump:
Note: Water will remain in hoses even when the tub
appears empty. Use care to avoid water spills.
1. Disconnect power to the machine.
2. Lower the drain hose into a small bucket to
remove any water remaining in hose.
3. Remove the front panel. (See
4. Disconnect the pump wires.
5. Pinch off the black sump hose to prevent water
spills.
6. Remove hose clamps and hoses from the pump.
7. Remove two -in. hex-head screws.
3 /
8
Sump Hose
Drain Pump
•
•
•
)
Front Panel.
To replace the drive belt using the tool kit:
Note: If not using the belt install tool, follow steps 1
through 3, and 6 through 7. Remove wire tie after
step 7.
1.
2.
3.
4.
5.
6.
Pump Wires
7.
8.
– 20 –
Belt
Since the belt provides constant tension, there is
no need for adjustments (an adjustment method
is not provided).
A worn or damaged belt can result in excessive
brake time and will initiate a motor inverter
slipping belt error code. This code will prevent
the inverter/motor from operating.
To replace the drive belt it may be helpful to use
the belt install tool (part number WX05X10102).
Belt Install Tool Kit
Disconnect power.
Remove the front panel. (See
Center belt on drive pulley and secure tightly
with wire tie as shown on following page. Align
wire tie as shown.
Stretch the belt install tool to fi t over the end of
the motor shaft. (See Figure A.)
Slide belt install tool upward until it snaps into
the fi rst groove of the motor shaft. (See Figure
B.)
Center belt on motor shaft grooves and slowly
turn drive pulley clockwise.
Continue rotating drive pulley until belt is fully
engaged.
Remove wire tie and belt install tool.
.)
Front Panel
(Continued next page)