Quinny XL Freestyle 4 Instructions For Use & Warranty page 21

GB
Removing the Maxi-Cosi car seat
- Place your thumbs on the control buttons on both sides of the car seat (19.1).
- Push in the buttons while lifting the car seat from the Freestyle 4 XL (19.2).
Removing the adapters
- Remove the adapters by moving the red button under the adapters outward (20.1) while sliding the adapters
upwards (20.2).
- Place both guards back in the adapter connections.
When used as a pushchair (see illustrations 21 – 34)
Placing the pushchair seat
- The pushchair seat can be used either forward-facing or backward-facing (22/24).
- Attach the pushchair seat by placing it with the hooks under the seat bottom on both the rods on the frame
(21).
- Press the pushchair seat downwards on both rods until it "clicks" (22).
- Check to make sure the pushchair seat is secure by pulling on it.
- Remove the pushchair seat by pulling on the handle (on the back of the seat bottom) and pulling the
pushchair seat upward (23).
Footrest
- The footrest can be adjusted into 2 positions.
- Press both buttons under the footrest at the same time (25.1) and move the footrest to the desired position
(25.2).
- IMPORTANT: Never let your child sit or stand on the footrest.
Back adjuster
- The back of the pushchair seat has multi-positional adjustment.
- To adjust the back, pull the handle in the middle of the back upward (26.1) while pushing the back up or
down (26.2).
Attaching/removing sun canopy
- Push both ends of the sun canopy onto the tubes below the plastic part of the back leg and above the
projection on the tubes (27.1).
- Fasten the 2 snaps on the back of the sun canopy to the pushchair seat (27.2).
- To remove the sun canopy, unfasten the snaps and pull off the sun canopy.
Safety harness
- Apply the brakes on the Freestyle 4 XL.
- Make sure the safety harness is loosened before placing your child (carefully!) into the seat.
- Fasten the lap and shoulder belts to the crotch strap (29).
- Adjust the belts to the size of your child by lengthening or shortening the belts using the clasps (30).
- Push the buttons to open the fastener (26).
- There are D rings for securing an additional safety harness. Make sure any safety harness you use meets the
following standard: BS 6684.
- The shoulder belts are height adjustable. To adjust the height, open the cover on the back and move the clasp
in both the cover as well as the reinforcement board (34).
Safety bar
- Place the 2 ends of the safety bar into the openings on the adapter connections (31).
- Important: Always fasten your child securely using the safety harness.
- Remove the safety bar by pushing both buttons on the end while pulling up the safety bar.
- Important: The safety bar cannot be used when using the seat in a rearward-facing position.
20