Vetta PathFinder II Wireless Quick Start Manual

PathFinder II Wireless (#500-108)
& PathFinder II (#500-109)
Patent NO.: 7.988.344
QUICK START MANUAL
For more details, please refer to the full manual
inside the mini-CD included with the product.
Warning: Inseting the mini-CD into a slot-loading
drive may damage your drive.
Installation
Installing the Headlight
1
Step 1: Press the notch at the
bottom of the computer
to detach the cover on
the computer.
2
Step 2: Align the notches on the
light with the holes on the
computer. Press and lock
the light housing to the
computer.
3
Step 3: The light and the computer
are now ready to use.
Installing the Battery
The head unit of PathFinder II series computer
uses a CR2032, 3-Volt Lithium button cell battery
while the headlight is powered by 3xAAA batteries.
For PathFinder II Wireless:
The wireless speed sensor uses an A23, 12-Volt
battery.
Installing the Mounting Bracket & Head Unit
For PathFinder II Wireless:
For PathFinder II:
Detaching the Computer
Press
Installing Speed Sensor & Magnet
For PathFinder II Wireless:
Step 1: Attach the wireless speed sensor & rubber
pad to the front of the left fork or the back
of the right fork leg using screw strap or
zip-ties provided.
Front
OR
Using Zip-Ties:
Front
Step 2: Adjust the sensor and magnet spacing with
the spacer. Remove the spacer after fixing
the sensor in its final position.
Using Screw Strap:
OR
Using Zip-Ties:
Step 3: Press the Alignment Button to check if
the speed sensor has been aligned correctly
with the magnet. If successfully aligned,
the speed sensor will produce a beeping
sound when the magnet moves over the
speed sensor.
Using Screw Strap: Using Zip-Ties:
For PathFinder II:
Step 1: Attach the wired speed sensor with the
zip-ties supplied and tighten the bladed
spoke magnet to the bicycle.
Note: Mount the sensor as high up
on the fork leg as possible.
Step 2: Adjust the sensor and magnet spacing
with the spacer.
Step 3: Remove the spacer after tightening the
zip-tie down to hold the sensor in its final position.
To avoid damaging or cutting the wires
accidentally, use the tape provided with the
package (NOT the zip-ties) to secure wires to
the frame, fork, bars or stem.
Front
Wire Securing Tape
Make sure excess wire is taped down or wrapped
around brake cable housing. Be sure to leave
Front
enough slack in the wire to accommodate the
movement of fork and handbar.
Button Function and Setup
PathFinder II series cycling computer is programmed
to enter the Intial Setup Mode after replacement
of new battery or All Clear Total Reset.
3
1
In Normal Operation
Press Momentarily:
Button 1 : Freeze Frame Memories
Button : Mode-Advance to next mode
2
Button 3 : Headlight Mode-Scroll different modes
of the headlight (ON
Button : Enter Setup Mode
4
Press & Hold for 2 Seconds:
2
Button 1 & : Reset Ride Date Including Frozen
Screens
Button : Recall Freeze Frame Memories
1
Button 1 , 2 & 4 : Total Clear Reset
In Initial Setup
Button 1 is used to toggle between different
settings and to confirm the selected value.
Button 2 is used to scroll through the values
(0~9) (press & hold for fast advance).
12 / 24 Clock
3
4
1
2
2
FLASH OFF)
2