Securing The Rp2 To A Counter Top - HP RP2 Hardware Reference Manual

Securing the RP2 to a counter top

1. Turn off the computer properly through the operating system, then turn off any external devices.
2. Disconnect the power cord from the power outlet.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
3. Tilt the display head back (1), and then push the neck of the stand back to a full vertical position
(2) to access the screw holes on the base of the stand.
NOTE:
base securely with one hand while forcing the neck back with the other hand.
4. There are two screw holes on the base of the stand. Fasten the stand to the counter top using
the appropriate fastening devices (not provided by HP) for your surface.
28 Chapter 2 Hardware upgrades
Regardless of the power-on state, voltage is always present on the system board
It takes some force to push the neck of the stand back to the vertical position. Hold the