Routing Cables To External Devices - HP RP2 Hardware Reference Manual

Retail system
Table of Contents

Advertisement

Routing cables to external devices

1.
Turn off the computer properly through the operating system, then turn off any external devices.
2.
Disconnect the power cord from the power outlet.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
3.
Push up on the bottom corners of the cable cover (1) and rotate the cover off the unit (2).
4.
Connect the cables to the appropriate rear connectors.
NOTE:
5.
Route the cables from the connectors on the rear panel through the hole in the center of the
base (1), and then out the underside of the base (2). Secure the cables with the cable clip (3).
8
Chapter 2 Hardware upgrades
Regardless of the power-on state, voltage is always present on the system board
Tilt the display head back for easy access to the rear connectors.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents