Micros Systems Ultra Setup Manual page 16

1st Page
Contents
Advanced Menu
This menu provides several sub-menus where you access many of the
Ultra system board hardware features.
Plug & Play O/S
This selection determines if the operating system on the hard disk
supports the Plug and Play specification.
Reset Configuration Data
Selecting Yes resets the BIOS Plug and Play configuration data.
This field automatically resets to No after a re-boot.
Secured Setup Configurations
If Yes, prevents a Plug and Play operating system from changing
any system settings.
Local Bus IDE Adapter
This selection enables/disables the system board IDE interface. By
default, this selection is "Enabled" to ensure a hard disk can be
detected automatically when it is installed.
PS/2 Mouse
This selection enables or disables the rear panel PS/2 mouse port.
When set to [AUTO] (default), it is up to the operating system to
detect and use the mouse. [Disabled] disables the PS/2 mouse port
and frees up IRQ12 for other uses.
PCI Device Slot
This selection allows you to designate a PCI card installed in the
Ultra PCI/ISA Riser Card as a Master. Some very old PCI cards
may require this. Consult the documentation supplied with card.
PCWS Ultra Setup Guide
_
If using Windows 95 or 98, select [Yes].
If using any version of UNIX, or Windows NT Workstation
Version 4.00 select [No].
WARNING:
If this field is not set to match the operating system as
described above, you may experience problems with
the on-board AMD Ethernet controller.
Setup Utility
Advanced Menu
2-5