Dinette Conversion (With Free-Standing Table); Sofa Conversion (If Equipped); Sleeper Sofa Conversion (If Equipped); Folding Doors/Privacy Curtain Dividers - Fleetwood EXPEDITION User Manual

remove the table leg(s) and if necessary,
store them between the seats.
3. Raise front portion of table several inches
to disengage inserts from the wall supports.
4. Lower table top to the dinette frame to
complete the bed base.
5. Slide seat and back cushion into place over
the bed base.
The under-seat storage may be reached by
raising the cushion platform.
Dinette Conversion
(with Free-Standing Table)
To convert the dinette into a bed:
I. Lift table, reach underneath, fold up the
legs under the table top. Secure the legs.
2. Lower table top to the dinette frame to
complete the bed base.
3. Slide the seat and back cushion into place
over the bed base.
The under-seat storage may be reached by
raising the cushion platform.
v'1
NOTE
I
Lower the dinette table to the bed position before
transporting the RV.
Sofa Conversion
(If Equipped)
To convert a sofa bed into a bed:
1. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick panel)
up and out. The back of the sofa will drop
back and down as the seat is pulled outward.
To restore the sofa/lounge:
1. Lift the front edge of the sofa seat up, and
push it back towards rear. The sofa back
will come up.
2. Push the sofa fully into position.
Living With Your Motor Home
Sleeper Sofa Conversion
(If Equipped)
To convelt a sleeper sofa into a bed:
1. Remove sofa cushions.
2. Lift front of sofa seat (above front kick
panel) up and out. While lifting the seat
out, the middle legs will automatically
unfold into a vertical position.
3. Pull upward on the center of the metal bar,
and rotate it down slowly until the wood
bars rest on the floor.
To restore the sleeper sofa:
I. Lift the front edge of the bedframe up and
rotate it back.
2. Lift the middle section of the bed up and
push it back towards the rear until the bed
is fully into position.
3. Replace the cushions.
Folding Doors/Privacy Curtain
Dividers
The dividers allow you to separate areas in the
motor home. They glide on nylon rollers. They
are held closed by a catch. When the dividers are
open for traveling, be sure to attach the hold back
latch to keep them from sliding back and forth.
Interior Lighting
Both decorative and 'utility' style 12-volt light-
ing fixtures may be used in your motor home.
Utility style fixtures may be either single or
dual. A slide switch selects either single or dual
brightness. For your convenience, some lights
are operated from wall switches. Clean the
lenses with soapy water.
CAUTION
Some of the lighting fixtures may be equipped with
halogen bulbs. The bulbs and fixtures may get very
hot when they are on. Do not touch these lighting fix-
tures when they are on. Allow them to cool before
attempting to replace a bulb or to clean. Replace all
light bulbs with the same type and wattage as origi-
nally installed or as indicated on the fixture.
06-5
. _ -
I -~·~-·c