Table of Contents
Advertisement
Installation information
Do not place any devices that
produce heat (such as a toaster or
microwave) on top of the appliance.
This would increase the energy
consumption of the appliance.
This fridge/freezer should not be
placed side-by-side with another
one.
Because the appliance does
not?have heated side walls, a
side-by-side arrangement can
lead?to a build-up of condensation
water.
Contact your dealer for advice.
Location
The appliance should not be installed
directly next to a heat source (such as
a kitchen range or a heater) or under a
window in direct sunlight. The higher
the ambient temperature, the longer the
appliance?will run and the higher the
energy consumption.
Choose a dry, well-ventilated room for
installation.
Climate class
The appliance is designed for use
within a certain climate range (room
temperature range) and should not be
used outside this range. The climate
range is stated on the data plate inside
the appliance.
Climate class
SN
N
ST
T
54
Room temperature
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
If the room is too cold, it will cause the
cooling system in the appliance to
remain off for too long. This may lead to
higher temperatures in the appliance
and the frozen food may even start
thawing.
Proper ventilation
The air behind the appliance gets
warm. In order to ensure adequate
ventilation, you must make sure that the
ventilation slits are not covered or
blocked in any way.
Also, the ventilation slits must be
dusted or cleaned on a regular basis.
Installation
^ First remove any cable clips from the
rear of the appliance.
^ Check that all the parts on the rear of
the appliance are free to move.
Carefully bend any attached
components out of the way.
^ Gently slide the appliance into the
desired location.
^ The rear of the appliance can be
directly against the wall.
Advertisement
Table of Contents
