Additional Heater; Fuel-Driven Additional Heater - Volvo V40 Cross Country Owner's Manual

Sym- Mes- Specification
bol sage
Fuel Setting the heater
operated is not possible due
heater to fuel level being
too low - this is in
stopped
Low fuel order to facilitate
starting the engine
level
as well as
approx. 50 km
driving.
Fuel
Heater not work-
operated ing. Contact a
heater workshop for
Service repair. Volvo rec-
ommends that you
required
contact an author-
ised Volvo work-
shop.
A display text clears automatically after a time
or after one press on the indicator stalk
(p. 106) OK button.
Related information
•
Engine block heater and passenger com-
partment heater* - direct start (p. 138)
•
Engine block heater and passenger com-
partment heater* - timer (p. 139)
4 An authorised Volvo dealer has information regarding the geographical areas concerned.
For cars equipped with parking heater (p. 137).
5

Additional heater*

For cars with diesel engines sold in cold cli-
mate zones 4 an additional heater may be
required to obtain the correct operating tem-
perature in the engine and to obtain sufficient
heating in the passenger compartment.
In such instances, the car is equipped with
either
•
electric additional heater (p. 142) or
•
fuel-driven additional heater (p. 141)
Related information
•
Engine block heater and passenger com-
partment heater* (p. 137)
04 Climate control

Fuel-driven additional heater*

The car is equipped with either an electric
(p. 142) or a fuel-driven additional heater
(p. 141).
The heater starts automatically when extra
heat is required when the engine is running.
The heater is switched off automatically when
the correct temperature is reached or when
the engine is switched off.
5
.
NOTE
When the auxiliary heater is active there
may be smoke from underneath the car,
which is perfectly normal.
Auto mode or shutdown
The additional heater's automatic start
sequence can be switched off if required.
NOTE
Volvo recommends that the fuel-driven
additional heater should be switched off
for short distances.
1. Before starting the engine: Select key
position I (p. 77).
2. Press OK to access the menu.
*
Option/accessory, for more information, see Introduction.
04
}}
141