Grizzly G0795 Owner's Manual page 39

Headstock Elevation Leadscrew &
Bevel Gears
Lube Type ..Model T23964 or NLGI#2 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ......... 90 hrs. of Operation
Tool Needed
Hex Wrench 3mm .............................................. 1
Remove rear cover of the column to access the
leadscrew and bevel gears (see Figure 55).
Leadscrew
Leadscrew
Bevel
Gear
Figure 55. Column rear cover removed to
access headstock elevation leadscrew and bevel
gears.
Use shop rags, a stiff brush, and mineral spirits to
clean away the grease and grime from the compo-
nents. When dry, apply a medium coat of grease
to the components and threads of the leadscrew
and gears. Move the headstock up and down
a few times to evenly distribute the lubricant.
Re-install rear cover.
Model G0795 (Mfd. Since 02/15)
Quill Rack & Pinion
Lube Type ..Model T23964 or NLGI#2 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ......... 90 hrs. of Operation
Move the quill up and down to gain full access
to the quill rack-and-pinion (see Figure 56), then
Qty
clean the teeth with mineral spirits, shop rags, and
a brush.
Crank
Bevel
Gear
When dry, use a brush to apply a thin coat of
grease to the teeth, then raise/lower the quill sev-
eral times to evenly distribute the grease.
Note: Re-apply oil to the quill outside smooth
surface that may have been removed during the
cleaning process.
Rack
Figure 56. Quill rack-and-pinion.
Pinion
-37-