Routing
The Routing menus are used to view the routing table and setup static routing.
Click Refresh to update the routing table.
Static Routing
Use Static Routing to specify a route used for aggregate traffic distributed to multiple routers within your
Ethernet LAN or to route data on the WAN. This is used to specify that all packets destined for a particular
network or subnet use a predetermined gateway. Static routing on the WAN is only supported if your WAN
connection protocol is not using PPPoE.
To add a static route to a specific destination IP address, enter a Destination LAN IP address, select a
suitable Subnet Mask, and type in the Gateway IP address. Click the Add button to create the static route.
Note: Static routes are typically used on enterprise networks where multiple routers
are in use. For small networks using a single router, this function is not normally
needed.
DIR-100 Triple Play Router
Routing Table
Static Routing menu
34