Table of Contents
Advertisement
MAINTENANCE
1
1. Exhaust vent
2. Inhalation vent
1
1. Commutator
2. Insulating tip
3. Carbon brush
1
1. Brush holder cap
2. Screwdriver
ACCESSORIES
12
001167
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
The tool and its air vents have to be kept clean. Regularly
2
clean the tool's air vents or whenever the vents start to
become obstructed.
Replacing carbon brushes
001146
When the resin insulating tip inside the carbon brush is
2
exposed to contact the commutator, it will automatically shut
off the motor. When this occurs, both carbon brushes should
be replaced. Keep the carbon brushes clean and free to slip
in the holders. Both carbon brushes should be replaced at
3
the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
001154
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
2
Makita replacement parts.
CAUTION:
•
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
•
Your tool is supplied with a guard for use with a
depressed center grinding wheel, multi-disc, flex wheel
and wire wheel brush. If you decide to use your Makita
grinder with approved accessories which you purchase
Advertisement
Table of Contents
