Parts Names - Sanyo VCC-6572P Instruction Manual

PARTS NAMES

3
4
1
5
2
1 2
3 4
1 Y signal ground
2 C signal ground
3 Y signal: 1.0 Vp-p,
75 ohms, unbalanced,
negative sync
4 C signal: 0.3 Vp-p,
75 ohms, unbalanced
3
English
1
Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.
2
12 V DC input terminal (12 V DC, GND)
Connect DC connecting cord to the 12V DC input terminal on the camera.
3
Y/C OUT connector
Using a coaxial cable (twin type, 75 ohms), connect the Y/C OUT connector from the camera to the S-VIDEO
input terminal on the monitor or time lapse VCR.
4
Power indicator (POWER)
Comes on when the power to the camera is on.
5
External sync composite video signal input connector (VBS IN: BNC type)
Connect to this connector the synchronizing signal output from a synchronizing signal device or the composite
signal of a video distributor.
Power supply connections
Use a 2 wire grounded cable (22 AWG or more), and connect as shown by the illustration.