* Manufacturer reserves t h e right t o change specifications w i t h o u t notice Note: Specifications may differ f r o m country t o country. Dust Collector load ,o,ooo (20") ( 1 1-114'' MODEL 410 Dimensions weight mm x 280 11") 120.4 Ibs) 1 1 . 1 1 4 "...
SAFETY INSTRUCTIONS Wh n sing an electrical appliance, basic precaution always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING injury: 1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. 2.
Use extra care when cleaning on stairs. 15. Do not use t o pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. 16. EXTENSION CORDS: Use only three-wire extension cords which have three- prong grounding-type plugs and three-pole receptacles which accept the tool's plug.
GROUNDING INSTRUCTIONS This appliance must be grounded. If ing provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment- grounding conductor and grounding plug. The plug must be plugged into an ap- propriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
1. When using this tool to collect dust into the dust bag Installing hose Attach the end of hose (the metal end) to the inlet. To attach it, align the protrusions on the inside of hose with the slots in the inlet, push the hose in and turn wise.
Overload protector The overload protector automatically cuts out to break the circuit whenever heavy work is prolonged. If this occurs, first turn off the main switch and unplug the tool. Then de- tach the hose and the inlet from the tool and remove the foreign matter clogging the fan. Now attach the inlet and the hose and press the restart button.
The tool will stop when the carbon brushes wear to both carbon brushes should be replaced. To maintain product SAFETY and RELlABl LITY, reparis, maintenance or adjustment including brush inspection and replacement should be performed by Makita Authorized Factory Service Centers, always using Makita replacement parts. indoors to outdoors from ”...
ACCESSORIES C A U T I O N : These accessories or attachments are recommended for use with your Makita tool specified in this any other accessories or attachments might present a risk of injury to persons. The manual. The use accessories or attachments should be used only in the proper and intended manner.
If you connect this dust collector to a Makita planer or planer-jointer, you can perform clean, dust-free operation. CAUTION: .When dust or shavings exhausted from the planer or planer-jointer are large run the planer or the planer-jointer under light load. Otherwise the clogged.
Y-joint assembly Part No. 122342-3 (For Model 2030, 2030N) Can be used t o collect chips and sawdust from auto-planer or jointer feed side by switching. 2030N Hood for Model Part No. 191 71 9-3 2040 Hood for Model Part No. 191721-6 2012 Hood for Model Part...
-31-85 DUST COLLECTOR Model 410 Note: The switch, noise suppressor and other part configurations may differ from country to country.
SEQUENTIAL DAMAGES FROM THE SALE APPLIES BOTH DURING AND AFTER THE TERM O F THIS WARRANTY. MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED WARRANTIES, INCLUDING IMPLIED WARRANTIES O F "MERCHANTABILITY" AND "FITNESS FOR A SPECIFIC PURPOSE," AFTER THE ONE-YEAR TERM O F THIS WARRANTY.