Makita HP2070F Instruction Manual page 8

1
1. Action mode changing lever
ASSEMBLY
1
3
2
4
1. Grip base
2. Side grip (auxiliary handle)
3. Teeth
4. Protrusions
8
CAUTION:
• Use the speed change knob only after the tool comes to
a complete stop. Changing the tool speed before the tool
stops may damage the tool.
• Always set the speed change knob to the correct
position. If you operate the tool with the speed change
knob positioned halfway between the "I" and "II" position,
the tool may be damaged.
Selecting the action mode
004289
This tool has an action mode change lever. For rotation with
hammering, slide the action mode change lever to the right
( symbol). For rotation only, slide the action mode
change lever to the left (
CAUTION:
• Always slide the action mode change lever all the way to
your desired mode position. If you operate the tool with
the lever positioned halfway between the mode symbols,
the tool may be damaged.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle)
002693
Always use the side grip to ensure operating safety. Install
the side grip so that the teeth on the grip fit in between the
protrusions on the tool barrel.
Then tighten the grip by turning clockwise at the desired
position. It may be swung 360° so as to be secured at any
position.
symbol).