Installing The Drivers; Installation Sequence For Base Drivers; Post-Installation Procedures - IBM SurePOS 700 Series Operating System Installation Manual

Updated October, 2007
30. Right-click My Computer on the Desktop and click Properties.
31. Click the Hardware tab.
32. Click Device Manager.
33. Double-click Ethernet Controller under Other Devices.
34. Click the Driver tab.
35. Click Update Driver.
36. Click Next.
37. Insert the floppy disk containing the Windows XP Network Driver in to the A:
38. Click Search for a suitable driver for my device and click Next.
39. Ensure the checkbox beside Floppy disk drives is checked and click Next.
40.
41. Click Finish to complete the installation process.
42. Click Close to exit the Ethernet Controller properties.

Installing the drivers

These drivers and update packages must be downloaded and installed in the order
shown below to ensure the system functions properly.
Note: Check the IBM Retail Store Solutions Web site at http://www.ibm.com/

Installation sequence for base drivers

Note: Check the readme.txt files for specific driver information.
1. Chipset
2. Network
3. Windows XP Service Pack 2 and other patches
4. Video
5. Audio
6. Base/PCI Serial Ports

Post-installation procedures

Install Intel Application Accelerator. This program will post a warning message
when one of the RAID disks degrades or disappears. It also automatically starts
Rebuilding the RAID volume when Windows restarts. Rebuilding scans the entire
disk and can take a considerable time to complete; however, the program displays
the percentage of completeness of the rebuilding.
drive.
Windows will find the proper driver on the floppy disk. After the search has
completed, click Next to continue.
solutions/retail/store/support for the latest driver updates.
Chapter 3. Installing Windows XP
15