Figure 2. Disk drive failure
2. Determine which hard disk drive has failed by opening the detected hard drive
3. Initiate shutdown and power off the machine (Start > Shutdown, press the
4. Continue with the steps described in "Replacing and rebuilding a hard drive" on
Method two: Entering RAID during start-up
1. Shutdown and reboot the machine (Start > Shutdown, press the power switch,
2. During the reboot, a screen appears that displays information on the failing disk.
22
SurePOS 700 Series: SurePOS 700-722/742/782, 723/743/783 Operating System Installation Guide
(see Figure 2). In the example, the detected hard drive's Device Port is 1;
therefore, the failed hard drive is located on Device Port 0.
power switch, or follow the procedure for your business).
page 23.
or follow the procedure for your business).
Note the Device Port number of the failing disk.
Updated October, 2007