Installation Instructions - Keystone KSTAW08A User Manual

Air Directional Louvers
Levers
Air Direction
Your air conditioner is designed to install in standard double hung windows with opening widths of
23 to 36 inches(584mm to 914mm) (See Fig.1).
EX ERIOR T
OFFSET
WALL
STOOL
SILL
INTERIOR
WALL
Mounting Hardware
3 4 Screws
Lock Frame
(7)
(2)
Top Rail Hardware
3 8 Screws
(4)

INSTALLATION INSTRUCTIONS

Lower sash must open sufficiently to allow a clear vertical
opening of 15-1/2 inches (394mm). Side louvers and the rear
of the AC must have clear air space to allow enough airflow
23 to 36
584mm to 914mm
through the condenser, for heat removal. The rear of the unit
15 1 2 min. /
must be outdoors, not inside a building or garage.
(394 mm)
Fig.1
Sash Lock
(1)
Top Rail
(1)
The louvers will allow you to direct the air flow Up
or Down and Left or Right throughout the room as
needed. Pivot horizontal louvers until the desired
Up/Down direction is obtained.
Move the Levers from side to side until the desired
Left/Right direction is obtained.
NOTE: Save Carton
for future reference. The carton is the best way to store unit
during winter, or when not in use.
Table 1
8000Btu/h
Model
Size
14 (356mm)
TOOLS NEEDED:
Phillips Screw Driver
Drill(If pilot holes are needed)
CAUTION: When handling unit, be careful to avoid cuts from
sharp metal edges and aluminum fins on front and rear coils.
NOTE: The top rail hardware and the following Fig.A,
Fig.B and Fig.C are not applicable to the units
than 10000Btu/h.
Before installing unit, the top rail must be assembled
on the unit (For <10000Btu/h models only).
Tool Needed: Phillips Screwdriver
A: Remove the air conditioner from the carton and place
on a flat surface.
B: Remove top rail from the bottom of the packaging
material as shown in Fig.A
10
and these Installation Instructions
10000-12000Btu/h
15-1/2 (394mm)
more