How To Know Your Emergency Pin Code - LaserLine 290i2 User Manual

DISARMING USING THE EMERGENCY PIN CODE (290i2/212 Only)
This function only applies if there is no optional electronic key.
If all the remote controls have been lost or are malfunctioning, you can disarm the alarm system
using the "emergency pin code".

HOW TO KNOW YOUR EMERGENCY PIN CODE

To display the emergency pin code (Pin Code), wait 10 seconds after the memorisation of the last
remote control or just follow points 1,2,3 of the " Auto-learning" procedure and wait 10 seconds.
The system will use the LED on the dashboard to present a series of 5 flashes that will correspond
to 5 numbers.
For the numbers
5 F
6 F
0 F
5 F
4 F
On the above example, the Pin Code to note at the end of these instructions would be 5 6 0 5 4.
It is imperative to note on a piece of paper this pin code, if it is different from the original pin code
displayed in the rear of these instructions. This pin code must then be stored in a secure location.
Note: If you intend to leave these instructions in the vehicle, the pin code in the back of these
instructions should be removed for safe keeping.
This pin code is derived from the first remote control memorised when you auto-learn a new
remote control. If you want to change the pin code from the original code, you may have to follow
the auto-learning procedure more than once alternating the first remote control until a new pin
code is given.
ISUT291-213UK.p65
n° of corresponding flashes
n° 5 consecutive LED flashes
n° 6 consecutive LED flashes
n° 10 consecutive LED flashes
n° 5 consecutive LED flashes
n° 4 consecutive LED flashes
6
2 sec. Pause
F
2 sec. Pause
F
2 sec. Pause
F
2 sec. Pause
F
2 sec. Pause
F
11/05/2006, 18.53