Speed Dial - Toshiba CIX series User Training Reference

When a local Attendant "splits" two callers that were conferenced, voice
recording stops. When a remote Attendant "splits" two callers, voice
recording is unaffected.
If a recorded call is put on Line hold, voice recording stops when that held
call is picked up by another station. When the held call is in a different
node, voice recording is unaffected when the held call is picked up.
ACD or Attendant call monitoring cannot be used if voice recording is
taking place. Conversely, if ACD or Attendant call monitoring is taking
place, you cannot use voice recording.
Pause/Resume Recording
You can pause the recording while continuing the conversation by pressing PS/RES. The
PS/RES LED flashes red. Your conversation is no longer being recorded. To resume
recording as part of the same message, press the PS/RES button again. You can pause
and resume indefinitely throughout the conversation. The only limit may be a message
length imposed by the voice mail system.

SPEED DIAL

Storing a System/Station Speed Dial Number
1. Dial #66. The display shows "SPEED DIAL" and you hear Entry Tone.
2. Dial the Station Speed Dial number (100~199) or System Speed Dial number
(200~999). The LCD shows your digits and you hear Entry Tone.
3. Dial the telephone number to be stored + #. Include any required access and area
codes. The LCD shows "SPEED DIAL" + the Speed Dial Number + destination +
#. You hear Success Tone.
4. Release the telephone. To enter another number, repeat the process, starting with
Step 1. Refer to Table 6 below.
Example: To store a Station Speed Dial number on Index 100, dial #66 + 100 +
97432130 + #.
Feature Access Code Sequences Speed Dial (Storing a SD number)
1. Stations must be assigned/enabled Speed Dial capabilities in system programming
by an Administrator
2. Station SD #66 + nnn + Phone No.2 + # nnn = 100~199 SD bin numbers
3. System SD #66 + nnn + Phone No.2 + # nnn = 200~999 SD bin numbers