Setting The Timer; Temperature Display; Switching The Weighing Function Off; Troubleshooting - Silvercrest KH 1159 Operating Instructions Manual

Setting the Timer

The timer can be used in both a clock and a weighing
mode.
Der Timer enables you to set the clock for a specific
period of time, at the end of which a signal tone sounds.
The preset time runs as in a countdown.
r
➩ Press the T-SET button
the bell symbol appears in the above-left.
You can adjust the time accurately to the second.
If you hold down the ▲ Z/T
buttons, the time-indicators run through faster.
y
➩ Using the ▲ Z/T or the ▼ UNIT
programme in the desired ten-minute setting.
r
➩ Press the T-SET button once. Using the ▲ Z/T
t
or the ▼ UNIT button, programme in the des-
ired one-minute setting.
r
➩ Press the T-SET button once. Using the ▲ Z/T
t
or the ▼ UNIT button, programme in the des-
ired ten-second setting.
r
➩ Press the T-SET button once. Using the ▲ Z/T
t
or the ▼ UNIT button, programme in the desired
one-second setting.
r
➩ Press the T-SET button
You can reset the timer.
➩ Press the T-SET button r
As soon as the programmed time has expired, an
acoustic signal sounds. This signal can be switched
off by pressing on any button.

Temperature Display

When the scale is switched on, the display
shows the temperature in °C at the top right.
w
once. In the display
y t
or the ▼ UNIT
t
button,
y
y
y
to start the countdown.
to re-set the timer.
w
- 5 -

Switching the weighing function off

If you do not weigh anything for ca. 2 minutes the
scale automatically switches into the clock mode.
➩ To manually switch over to the clock mode, press
u
the button ON/OFF .
➩ When you no longer require the scales, fold the
i
glass plate back upwards.

Troubleshooting

w
➩ If the display indicates "Err", the scale is over-
burdened. Remove material from the scale.
Never place more than 4 kg on the scale.
w
➩ If the display briefly indicates "Err" and the
weighing mode cannot be switched on, the scale
is overburdened. Remove material from the scale
and then switch the scale back on again.
Place less than 4 kg on the scale.
w
➩ If the display indicates "Lo", the batteries are
depleted. Replace the batteries.
The indicator "Lo" only appears in the weighing
mode.
➩ If „- - - -" appears in the display
seconds.
➩ If your scale does not function as expected, replace
the batteries. Should the malfunction not be
eliminated with these steps please make contact
with our Service Centre (see "Warranty and
Service").
w
, wait a few