Canon MG6600 series Online Manual page 769

2. Click Advanced settings.
If the User Account Control screen is displayed, click Yes.
3. Select and right-click Inbound Rules, then select New Rule.
If you set outbound rules, right-click Outbound Rules.
4. Select Port, then click Next.
5. Select TCP, then select Specific local ports: and input "137", then click Next.
If you open UDP ports, select UDP.
If you open other ports, input the other port's number in Specific local ports:.
6. Select Allow the connection, then click Next.
7. Choose the profile for which this rule applies, then click Next.
8. Input any name and description, then click Finish.
9. Repeat steps 3 to 8 to open the other ports (138TCP, 138UDP, 139TCP, and 139UDP).
10. Confirm that the port names are added on the Inbound Rules screen, then close Windows
Firewall.
◦ If you are using Windows Vista or Windows XP:
1. Select items from the Start menu as shown below.
■ In Windows Vista, click Start > Control Panel > Security > Windows Firewall > Change
settings.
■ In Windows XP, click Start > Control Panel > Security Center > Windows Firewall.
2. Click the Exceptions tab, and click Add port.
3. On the Add a Port screen, input the following information, and click OK.
Name: Input any name for the port.
Port number: Input "137".
Protocol: Select TCP.
4. Repeat steps 2 and 3.
On the Add a Port screen, input the same information as you did in step 3 except for selecting
UDP in Protocol.
5. Repeat steps 2 to 4 to open the other ports (138TCP, 138UDP, 139TCP, and 139UDP).
6. Confirm that the port names are added on the Exceptions sheet, and click OK.
Change the workgroup name to "WORKGROUP" following the procedure
Check5
below.
Note
• Changing the workgroup name may have an effect on the network, so you need to ask the administrator to
change it.
1. Display the System properties screen as shown below.
• In Windows 8.1 or Windows 8, select the Explorer icon in Taskbar on Desktop, right-click Computer
from the list on the left, select Properties, then click Change settings.
• In Windows 7 or Windows Vista, right-click Computer, select Properties, then click Change settings.
• In Windows XP, right-click My Computer, then select Properties.
769