Adjusting The Feet - Beko EV 7103 User Manual

connection to check for water leaks at the
connection points. If any leaks occur, turn off
the tap and remove the nut. Retighten the nut
carefully after checking the seal. To prevent
water leakages and damages caused by them,
keep the taps closed when the machine is not
in use.
2.5 Connecting to the drain
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
A
WARNING
Do not remove the transportation
locks before taking out the packaging
reinforcement.
• The hose should be attached to a height
of at least 40 cm, and 100 cm at most.
• In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
ground), water discharge becomes more
difficult and the laundry may come out
excessively wet. Therefore, follow the
heights described in the figure.
• To prevent flowing of dirty water back
into the machine and to allow for easy
discharge, do not immerse the hose end
into the dirty water or do not drive it in
the drain more than 15 cm. If it is too
long, cut it short.
7 / EN
• The end of the hose should not be bent,
it should not be stepped on and the
hose must not be pinched between the
drain and the machine.
• If the length of the hose is too short, use
it by adding an original extension hose.
Length of the hose may not be longer
than 3.2 m. To avoid water leak failures,
the connection between the extension
hose and the drain hose of the product
must be fitted well with an appropriate
clamp as not to come off and leak.

2.6 Adjusting the feet

A
WARNING
In order to ensure that the product operates
more silently and vibration-free, it must
stand level and balanced on its feet.
Balance the machine by adjusting the feet.
Otherwise, the product may move from
its place and cause crushing and vibration
problems.
Loosen the lock nuts on the feet by hand.
Adjust the feet until the product stands level
and balanced. Tighten all lock nuts again by
hand.
A
WARNING
Do not use any tools to loosen the lock nuts.
Otherwise, they will get damaged.
Washing Machine / User's Manual