Appropriate Installation Location - Beko EV 7103 User Manual

2 Installation
Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, review the information
in the user manual and make sure that
the electricity, tap water supply and water
drainage systems are appropriate before
calling the Authorized Service Agent. If they
are not, call a qualified technician and plumber
to have any necessary arrangements carried
out.
C
INFORMATIONS
Preparation of the location and electrical,
tap water and waste water installations at
the place of installation is under customer's
responsibility.
Make sure that the water inlet and discharge
hoses as well as the power cable are not
folded, pinched or crushed while pushing
the product into its place after installation or
cleaning procedures.
B
WARNING
Installation and electrical connections of
the product must be carried out by the
Authorized Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out by
unauthorized persons.
A
WARNING
Prior to installation, visually check if the
product has any defects on it. If so, do not
have it installed. Damaged products cause
risks for your safety.

2.1 Appropriate installation location

• Place the machine on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
• Total weight of the washing machine
and the dryer -with full load- when they
are placed on top of each other reaches
to approx. 180 kilograms. Place the
5 / EN
product on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the power
cable.
• Do not install the product at places
where temperature may fall below 0ºC.
• Place the product at least 1 cm away
from the edges of other furniture.
2.2 Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the ribbon.
Washing Machine / User's Manual