Rdc-2 Operating Instructions; Alarm Operation; Authorized Personnel Only; Trouble Operation - Faraday MPC-6000 Installation, Operation And Maintenance Manual

MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL

RDC-2 OPERATING INSTRUCTIONS

In case of alarm, the Alarm LED flashes, LCD displays alarm condition and the buzzer activates on-
steady. Local audible and visual signals and remote alarm signals operate.
When an alarm occurs, proceed according to the established emergency plan. Assure that all personnel
are accounted for, and notify the Fire Department to advise of the alarm and/or verify that an automatic
signal has been received at the Fire Department.
To acknowledge the alarm:
To acknowledge the alarm, press the Acknowledge button. The local buzzer will be silenced and
the Alarm LED will change from on-flashing to on-steady.
Note: The alarm may only be acknowledged at the node which initiates the alarm or the
RND-2.
To silence the alarm:
To silence the notification appliances after evacuation, where permitted, operate the Button
Enable key switch and press the Alarm Silence switch. The silenceable notification appliances
will be silenced. The Alarm Silence LED will be on-steady.
Note: Do not reset the panel until the alarm has been cleared.
Warning: Alarm silence inhibit (if set) prevents the alarm from being silenced for a
predetermined time.
To reset panel after alarm:
When the alarm condition is corrected, return the panel to normal standby operation by placing
the Button Enable key switch to the OK position and then pressing the System Reset switch.
Trouble is indicated by:
Trouble LED flashes
LCD will display trouble conditions
Buzzer activates on-pulsing
To acknowledge the trouble:
Operate the Button Enable key switch to the ON position and press the Acknowledge button.
The Trouble LED changes to on-steady. When the trouble condition has been cleared, you may
need to reset the panel to restore to a normal standby condition.
Warning: Leaving the panel in a trouble condition may cause a fire alarm condition not to
initiate a fire alarm sequence
The green Power On LED will be lit and no other indicators on.
For service, contact: ___________________________________________
Telephone Number: ___________________________________________
Frame these instructions and mount them near the annunciator for operator reference.

Alarm Operation

Authorized Personnel Only

Trouble Operation

Normal Standby Condition

25