Advertisement
Mounting
blade
First, use the hex wrench to remove the
bolt
which secures the blade clamp to the
blade holder shaft. With the blade teeth
facing forward, place the shank of the
blade over the flat side of the blade holder
shaft. Then place the blade clamp over the
other side
of
the blade shank. Secure this
assembly together with bolt. Make sure
that the bolt passes through the larger hole
in the blade shank.
Using roller
With the hex wrench loosen the bolt which
holds the base and retainer. Slide the re-
tainer so that the roller contacts the blade,
then tighten the bolt.
Hex wrench
w
SDrina washer
Blade clamp
h
Blade holder shaft
Retainer
I I \
'
Roller
Blade
IU
Use
a
lubricant or cutting oil between the blade and roller when cutting metals. Failure
to do
so
will shorten the service life of your blade and roller.
7
Advertisement
