Advertisement
ADDITIONAL SAFETY RULES
FOR CHARGER & BATTERY CARTRIDGE
1.
Do
not charge Battery Cartridge when temperature is BELOW 10°C ( 5 O O F )
2.
Do not attempt t o use a step-up transformer, an engine generator or DC
3.
Do not allow anything t o cover or clog the charger vents.
4. Do
not short the battery cartridge. A battery short can cause a large current
flow, overheating, possible burns and even a breakdown.
5. Do not store the tool and Battery Cartridge in locations where the tempera-
ture may reach or exceed 5OoC (122OF).
6.
Do not incinerate the Battery Cartridge even if
it
is severely damaged or is
completely worn out. The battery cartridge can explode in a fire.
or ABOVE 4OoC (104OF).
power receptacle.
ADDITIONAL SAFETY RULES
FOR CORDLESS JIG SAW
1. Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
2. Do not cut hollow pipe.
3.
Do
not cut oversize workpiece.
4. Check for the proper clearance beneath the workpiece before cutting so that
5.
Hold the tool firmly.
6.
Check the blade is not contacting the workpiece before the switch is turned
7.
Keep hands away from moving parts.
8.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered, DO NOT TOUCH ANY METAL PARTS
OF
THE TOOL!
Hold the tool only by the plastic handle t o prevent electric shock if you cut-
ting through a "live" wire.
fore operation.
the blade will not strike the floor, workbench, etc.
on.
9.
Do not leave the tool running. Operate the tool only when hand-held.
10. Always switch off and wait for the blade t o come t o a complete stop before
11. Do not touch the blade or the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
5
Advertisement
