Getting Started; 1. Connecting Speakers; 2. Am/Fm Antenna Connections - Onkyo CR-N765 Instruction Manual

Getting started

1. Connecting speakers

Refer to the illustration below to connect the unit and the
right and left speakers with the speaker cables. Connect
the speaker to be placed on the right hand side to the
SPEAKERS terminal (R), and connect the speaker to be
placed on the left hand side to the SPEAKERS terminal
(L). Since the unit is equipped with the SUBWOOFER
PRE OUT terminal, you can enhance bass sound
playback by connecting a subwoofer with a built-in power
amplifier.
Important: Connect speakers with 4 h to 16 h
impedance. Connecting a speaker with a lower
impedance may damage the speaker.
Right speaker
Powered subwoofer
12-15 mm
Cut and remove the plastic coating from the end of the
speaker cable, twist the core and connect it to the
terminal. Make correct connection between the unit's
jacks and speaker's jacks (i to i and j to j) for each
channel. If connection is wrong, a bass sound may
become poor due to reverse phase.
0 Short-circuiting the i cable and j cable or contacting
the cable core to the rear panel of the unit may cause
12
failure. Also do not connect two or more cables to one
speaker terminal or one speaker to several terminals.
Left speaker

2. AM/FM antenna connections

Connect the antennas to listen to AM/FM broadcast.
When listening to the broadcast for the first time, adjust
the antenna position and orientation to get the best
reception.
Speaker cable
Fix with a tack on
the wall.
AM loop antenna (supplied)
Insert the plug fully into the
jack.
Indoor FM
antenna
(supplied)
Assemble the AM loop antenna (supplied).