Windows Control Panel - ICON Cube Owner's Manual

Windows Control Panel

Sample rate settings
Select your desired sampling rate from
44.1KHz to 192KHz on the pull down
window shown n Diagram 1. Click
"Apply" after the selection has been
made to set the value.
Buffer Size settings
You may select the buffer size for
"Streaming" and "ASIO". Click "Apply"
after you have made the selections.
(Note: If a clicking sound occurs, you
should change to a larger buffer size for the
settings. If the largest buffer size has been
selected and there is still a clicking sound. It
means your computer performance is not
able to handle the task. (It is not caused by
the Cube series digital audio interface)
Device settings
Shows the serial number & product ID of
your Cube/Cube Pro/Cube G/Cube
Mini/Cube 4 Nano or Cube DJ device. If it
doesn't show, it means your device is not
properly installed. Please go through the
"Driver Installation" process again
(Page 22).
Monitor Mixer
Click this button to launch the "Monitor
Mixer" (Page 26)
Playback Mixer
Click this button to launch the "Playback
Mixer" (Page 27)
S/PDIF Status and Pass Through (Cube
G/Cube 4 Nano only)
Showing the S/PDIF device signal status.
S/PDIF Pass Through (Cube G/Cube 4
Nano only)
"Tick" the box if you want S/PDIF signal
pass through
25
Diagram 1
Diagram 2
Diagram 3
Diagram 4