Canon Legria HF R36 Instruction Manual page 151

4 Within 2 minutes, touch [OK] on the camcorder's screen.
You can touch [Stop] and then [OK] to interrupt the Wi-Fi Protected
Setup while it is in progress.
5 Touch [Automatic] to automatically obtain an IP address.
• To assign the IP address manually, touch [Manual] and perform the
procedure in To manually assign an IP address below.
• A screen to test the settings will appear.
6 Select whether to test the settings.
• You can touch [Check Current Configuration] to review the network
settings.
• If you touched [Yes], a test of the settings will be performed and a
confirmation screen will appear. Touch [OK].
7 Save the settings of the connection point.
[Yes]
* After touching [OK], you can review the network settings. Touch [Wi-Fi Setup]
>
[Check Current Configuration]
[ 3])
To manually assign an IP address (step 5)
After touching [Manual] in step 5:
Touch the field under [IP Address] or [Subnet Mask]
Enter* the IP address or subnet mask
default gateway
secondary DNS servers
* An interface similar to the virtual keyboard for text fields (A 88) will appear except
it will contain only the keys necessary for this step.
Manual Setup
Perform this procedure to wirelessly connect the camcorder to the
wireless router (using infrastructure mode) if your router does not sup-
port WPS, you wish to manually configure settings, or if your wireless
router's network name (SSID) cannot be detected due to the stealth
function being enabled.
Downloaded From VideoCamera-Manual.com Manuals
> >
[OK]*
> >
[Î] or [Í]
>
[X]
>
Desired connection point ([
[K] three times when finished.
>
[OK] Enter the default primary and
> >
[OK]
> >
[OK] Enter the
Continue to step 6
Wi-Fi Functions
1] to
>
151