Timex Intelligent Quartz W273 Instructions Manual page 46

1. Pull the crown out to position 3. The 4th center hand
will point to 12 o'clock.
2. Rotate the crown to position the minute hand in the
correct position within the hour required for the loca-
tion you are wishing to use for the 2nd and 3rd time
zones.
3. Push the crown in to position 2. The 4th center hand
will point to its currently calibrated position of the
minutes within the hour.
4. Push button A to move the 4th center hand clockwise
until it aligns with the minute hand. Pressing and hold-
ing button A will make the hand move at a fast rate.
5. Pull the crown out to position 3. The 4th center hand
will point to 12 o'clock.
6. Rotate the crown to position hour and minute hands
to the correct time.
86
7. Push crown in to position 1 when finished.
Please note: The 4th center hand will track the time using
the current calibration of the minutes within the hour.
Time zones 2 and 3 both utilize the 4th center hand and
therefore the locations being tracked in time zones 2 and
3 must both utilize the same minutes within the hour for
these time zones to be displayed properly.
SETTING THE 4TH CENTER HAND (TIME ZONE II)
Note the current time in the location you wish to track
as the 2nd time zone. Press button A until the 4th center
hand is pointing to that time on the inner ring. (Please
note: this scale is a 24-hour format). The 4th center hand
will advance 30 minutes each time button A is pressed.
Pressing and holding button A will make the hand move at
a fast rate. This will set the 2nd time zone on the watch.
87