Installing The Rack Rail Hook-And-Loop Strap; Powering On And Selecting Boot Options - HP ProLiant DL120 Gen9 User Manual

WARNING:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
•
times.
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it.
•
Pay particular attention to the plug, electrical outlet, and the point where the cord extends from
the server.

Installing the rack rail hook-and-loop strap

The rack rail hook-and-loop strap can be installed on either the left or right rack rail. HP recommends
installing it on the left rack rail for better cable management.
To install the rack rail hook-and-loop strap:
Install the server into the rack
1.
Install the rack rail hook-and-loop strap:
2.
Hold the rear panel cables against the rack rail, and then wrap the strap around the rack rail.
a.
CAUTION:
rack, the extra length and buckle part of the strap must be facing the outside of the rack rail.
Loop the end of the hook-and-loop strap through the buckle.
b.
When multiple hook-and-loop straps are used in the same rack, stagger the strap location, so that the
straps are adjacent to each other when viewed from top to bottom. This positioning will enable the rack
rail to slide easily in and out of the rack.

Powering on and selecting boot options

Connect the Ethernet cable.
1.
To reduce the risk of electric shock or damage to the equipment:
("Installing the server into the
To prevent thermal or mechanical obstruction on full-length servers installed in the
rack" on page 31).
Setup 35