PRESONUS RM32AI Owner's Manual page 21

3 Networking the RM-series Mixer
3.4 Wireless Control Setup
Wireless Connection from Computer to Router
Every time you turn on your StudioLive RM-series mixer, it will:
1. Look for a wired Ethernet connection and use it if one is found.
2. If no wired connection is found, it will check whether
the USB Wi-Fi LAN adapter is plugged in.
3. If the Wi-Fi LAN adapter is found, the mixer will look for, and attempt
to connect to, the wireless network it has been configured to use.
Note: StudioLive RM-series mixers support only WPA and WPA2 security. Please
be sure that your router is configured using one of these security protocols.
Power User Tip: WPA and WPA2 are protocols created to make wireless
networks secure. WPA stands for "Wi-Fi Protected Access, " and WPA2 is a
later version that conforms to the IEEE 802.11i networking standard. Most
routers have settings that manage their security protocols; consult the
documentation for your router to learn how to change these settings.
To create this setup:
1. Configure a wireless connection between your computer
or iPad and a wireless Ethernet router.
2. Connect a standard CAT5e or CAT6 Ethernet cable from the
Control port of the RM-series mixer to the router.
3. Launch UC Surface software on a computer (Mac or Windows)
or iPad that is connected to the network you want to use.
4. The Universal Control launch window will appear and
should recognize the presence of your RM mixer.
Ethernet cable
StudioLive™ RM-Series Mixers
Owner's Manual
Laptop
17