Page 1
1300 772 776 INstructIoN mANuAl enquiry@psaproducts.com.au Choose for intercoms Choose for intercoms PAN780KID f i r e • s e c u r i t y • i n t e r c o m s f i r e •...
CONTENTS 1. FEATURES 21mm slim indoor monitor with touch buttons. Weather resistant outdoor camera Built in RFID reader within door camera for keyless entry. 7” LED screen, no radiation low power consumption and high definition. Hands free communication. Surface touch function. Unlock two doors respectively.
6. OUTDOOR CAMERA INSTALLATION Picture 1. Picture 2. 1.0 Nameplate To label the name plate, remove the 4 screws on the back of the door camera & carefully remove the cover. (picture 1) wall bracket Unclip the plastic nameplate cover, label the nameplate & clip back the plastic cover (picture 2) Refit the rear cover &...
Page 5
7. WIRING & MAINTENANCE INSTRUCTIONS Cable Specifications: • 0 to 30m: minimum CAT 5 or 5 Core Stranded 0.50mm2 • 30 to 80m: minimum 5 core Stranded 0.75mm2 To avoid any interference, all intercom cables should maintain 50mm separation from 240VAC wires Never install door camera directly facing sunlight. This will create a white image on indoor monitor and may damage the camera lens over time.
8. ID CARD PROGRAMMING This kit includes four pre-programmed cards. 1 x Adding Card 1 x Deleting Card and 2 x User Cards Follow the below steps to add, delete or re-program add/delete cards Adding User Cards: Step 1: use the adding card to touch the ID card touching zone of the outdoor station. Step 2: use the user card to touch the same area.
To end the conversation, touch TALK again. Talk mode will automatically shut down To the extent permitted by law, the liability of PSA Products Pty Ltd arising from the sale or under the after approximately 120 seconds if not ended.