Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PSA IntelLink INT27WSK
Summary of Contents for PSA IntelLink INT27WSK
- Page 1 Video Intercom Q U I C K S E T U P G U I D E model. INT27WSK...
-
Page 2: Kit Contents
TABL E OF CO NTEN T S Keep intercom wires more than 30cm away from AC mains power to avoid interference. The electric latch is not included in the package. Use 12VDC electric latch only. Do not exceed 500mA. KIT CONTENTS INSTALLATION For stable connection to the IntelLink app, internet data connection is required at both intercom and mobile device. -
Page 3: Wiring Diagram
W IR I NG D I AGRAM IN STA LL ATI ON Monitor Door Station *The first monitor is the MASTER monitor and ID must be set as Device 01. All other monitors are SLAVES and must be set as Device 02 to 06. To program the device ID go to MODE section.*... - Page 4 IN TELL I NK WIF I INT ER C OM B. Preparing the IntelLink Intercom for Connection M OB I L E A PP- S E T U P G U ID E 1. Power up the IntelLink Intercom A. Introduction 2.
- Page 5 C. Pairing Intercom to IntelLink App (Steps for AP-mode connection) 4. Confirm “AP Mode” is shown on top right corner of App screen. Tap the small circle to left of “Confirmed IntelLink Monitor has rebooted” . Tap “Next” to continue. (See Fig 4). 5.
-
Page 6: Warranty And Liability
3. To the extent permitted by law, the liability of PSA Products Pty Ltd arising from the sale or under the terms of this limited warranty shall not in any case exceed the cost of replacement and subject to this clause. - Page 7 17 Millicent Street, Burwood, VIC 3125 Australia Tel: 1300 PSA PRODUCTS (1300 772 776) Fax: (03) 9888 9993 enquiry@psaproducts.com.au psaproducts.com.au...
Need help?
Do you have a question about the IntelLink INT27WSK and is the answer not in the manual?
Questions and answers