Fixing The Frame - Smeg SHIG910X Instruction Manual

• Loosen the two screws fastening the lower chimney and remove this
from the lower frame.
• Loosen the two screws fastening the upper chimney and remove this
from the upper frame.
If you wish to adjust the height of the frame, proceed as follows:
• Unfasten the metric screws joining the two columns, located at the
sides of the frame.
• Adjust the frame to the height required, then refit all the screws re-
moved as above.
• Insert the upper chimney stack from above, and leave it running free
on the frame.
• Lift up the frame, fit the frame slots onto the screws up to the slot end
positions.
• Tighten the two screws and fasten the other two screws provided with
the hood.
Before tightening the screws completely it is possible to adjust the frame
by turning it. Make sure that the screws do not come out of their seats in
the slotted holes.
• The frame mountings must be secure to withstand the weight of the
hood and any stresses caused by the occasional side thrust applied to
the device.
On completion, check that the base is stable, even if the frame is sub-
jected to bending.
• In all cases where the ceiling is not strong enough at the suspension
point, the installer must provide strengthening using suitable plates and
backing pieces anchored to the structurally sound parts.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using
either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the
installer.
To install a ø 150 pipe
• To install the dumper 10
• Fix the pipe in position using sufficient pipe clamps (not supplied).
To install a ø 120 pipe
• To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on
the dumper 10.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
• Remove any activated charcoal filters.
EN

Fixing the frame

Connections
1
1
2 2
ø 150
25
10
ø 120
25
9
10
7 7