9 • Operating and Cleaning Your Ceiling use a solid-state speed control with this fan. Use only Hunter speed Fan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 controls.
Page 3
Support Brace Hunter’s patented 2-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on ceiling height and your preference: Standard or Angled mounting. The steps in this manual include instructions for Ceiling both Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Do not over tighten. Steps 2-3 – 2-5 Flat Washer Toward Ceiling Peak 3” Screw For Angled Ceilings: Be sure to orient the ceiling plate so that the two tabs are pointing toward the ceiling peak. 41467-01 • 09/30/09 • Hunter Fan Company...
3-4. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate. Go to 4 • Wiring the Fan . 3-5. Place the slots over the hooks to hang the fan. Step 3-5 Ceiling Plate Hooks Canopy Slots 41467-01 • 09/30/09 • Hunter Fan Company...
4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. 41467-01 • 09/30/09 • Hunter Fan Company...
2. Press firmly on opposite sides of the ring toward the canopy. The tabs will flex out releasing the trim ring from the canopy. Step 5-4 Step 5-3 Step 5-5 41467-01 • 09/30/09 • Hunter Fan Company...
6 • Assembling the Blades 6-1. Attach each blade to a blade iron using four blade assembly screws. Blade Assembly Screws Blade Blade Iron Step 6-1 41467-01 • 09/30/09 • Hunter Fan Company...
7 • Completing Your Installation With a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly. WARNING: Use only the light fixture supplied with this fan model. 7-1. Install included 100 Watt Halogen bulb. 7-2. Position the indentations in the outer rim of the glass shade so that they line up with the tabs on the inside surface of the light fixture rim.
Page 11
CAUTION: The remote control device complies with part 15 of the Tabs FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment. Operation is subject to the following two conditions: 1.
Note: The receiver (built into the fan) has a memory function that retains the last dipswitch code setting. The setting will not change in the event of power failure or if the power to the fan is inadvertently shut off. 41467-01 • 09/30/09 • Hunter Fan Company...
Clean painted and high-gloss blades in the same manner as the fan finish. To Change Airflow Direction Press the reversing switch on the remote while the fan is running. In cold weather, use upward air flow pattern 41467-01 • 09/30/09 • Hunter Fan Company...
If you need parts or service assistance, please call 888-830-1326 (In Canada, call 1-866-268-1936) or visit us at our Web site at http://www.hunterfan.com. Hunter Fan Company 7130 Goodlett Farms Pkwy. #400 Memphis, Tennessee 38016 41467-01 • 09/30/09 • Hunter Fan Company...