Specifications - JTS PT-850B/2 Instruction Manual

5 Setting the Transmitter into Operation
1) Connect the Lavalier microphone CM-501 supplied
to the mini XLR jack INPUT (3) and fasten it to your
clothes (e. g. tie or lapel) by means of the clip.
It is also possible to use another matching JTS
microphone with 4-pole mini XLR plug (see chap-
ter 3).
2) Before switching on the transmitter, set the receiver
to an interference-free transmission channel (see
instruction manual of the receiver).
3) Then switch on the transmitter: Set the sliding
switch (2) to ON. The LED status indication (4)
shows green to indicate normal operation. If it
shows red after switching on or during operation,
the inserted batteries are almost exhausted and
must be replaced.
4) Set the transmitter to the same channel adjusted on
the receiver: For this purpose, turn the rotary switch
CH (5) by means of the small adjusting key sup-
plied in such a way that the arrow will point to the
desired channel.
The 16 transmission channels are assigned to
the following transmission frequencies:
Channel Frequency
1 744.250 MHz
2 745.500 MHz
3 746.500 MHz
4 747.125 MHz
5 748.250 MHz
6 749.125 MHz
7 750.500 MHz
8 753.500 MHz
Note: If other wireless transmission systems are
operated with this wireless system at the same
time, the radio frequencies of the individual sys-
tems should be carefully matched to each other to
prevent interference.
5) Speak/sing into the microphone. The volume level
can be readjusted by changing the sensitivity via
the gain control (6). For turning the control, use the
adjusting key supplied. Adjust the transmitter to the
optimum level. If the level is too high, the transmit-
ter will distort; in this case, turn back the control (if
necessary, turn it to the left stop). If the level is too
low, a poor signal-noise ratio will result; in this case,
advance the control correspondingly.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
Channel Frequency
9 754.250 MHz
10 755.875 MHz
11 757.000 MHz
12 758.500 MHz
13 759.000 MHz
14 760.750 MHz
15 761.750 MHz
16 763.250 MHz
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
6) After all adjustments have been made, put the
transmitter back into the belt bag and secure it with
the Velcro fastener to prevent slipping out.
7) Fasten the belt bag to your clothes by means of the
Velcro strap on its rear side.
8) To switch off the transmitter after operation, set the
sliding switch (2) to OFF.

6 Specifications

Pocket transmitter
Type of unit: . . . . . . . . . PLL multifrequency pocket
Radio frequency range:. 740 – 764 MHz,
Audio frequency range:. 40 – 18 000 Hz
Frequency stability: . . . . ±0.005 %
Transmitting power: . . . 10 mW (EIRP)
Ambient temperature: . . 0 – 40 °C
Power supply: . . . . . . . . two 1.5 V batteries of size
Dimensions (w/o bag): . 68 × 195 × 25 mm
Weight: . . . . . . . . . . . . . 120 g
Microphone connection: 4-pole mini XLR jack
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
Lavalier microphone CM-501
Type of microphone: . electret microphone
Directivity: . . . . . . . . . cardioid
Frequency range: . . . 100 – 15 000 Hz
Impedance: . . . . . . . . 2.2 kΩ
Sensitivity: . . . . . . . . . 3.2 mV/ Pa at 1 kHz
Max. SPL: . . . . . . . . . 130 dB
Power supply: . . . . . . via the pocket transmitter
Connection: . . . . . . . . 4-pole mini XLR plug
Weight: . . . . . . . . . . . 20 g
Subject to technical modification.
®
transmitter with pilot tone
divided into 16 channels
(→ table, chapter 5)
AA (R6)
7