2.4 Ghz/5 Ghz Wireless Network - EnGenius ENH1750EXT User Manual

2.4 GHz/5 GHz Wireless Network

This page displays the current status of the Wireless
settings of the ENH1750EXT.
Operation Mode: Select Operation Mode. The ENH1750EXT
supports two different operation modes: Access Point, or
WDS (WDS AP, WDS Bridge, and WDS Station).
Wireless Mode: Supports 802.11b/g/n mixed mode in 2.4
GHz and 802.11ac/a/n mixed mode in 5 GHz.
Channel HT Mode: The default channel bandwidth is
20 MHz/40 MHz. The larger the channel, the greater the
transmission quality and speed.
Extension Channel: Select the upper or lower channel.
Your selection may affect the Auto channel feature.
Transmit Power: Sets the power output of the wireless
signal.
Data Rate: Select a data rate from the drop-down list. The
data rate affects throughput of data in the ENH1750EXT.
Select the best balance for you and your network but note
that the lower the data rate, the lower the throughput,
though transmission distance is also lowered.
RTS/CTS Threshold: Specifies the threshold package size
for RTC/CTS. A smaller number causes RTS/CTS packets to
be sent more often and consumes more bandwidth.
Client Limits: Limits the total number of clients.
Aggregation: Merges data packets into one packet. This
option reduces the number of packets, but also increases
packet sizes.
AP Detection: The AP Detection feature can select the
best channel to use by scanning nearby areas for Access
Points.
Distance: Specifies the distance between Access Points
and clients. Note that longer distances may drop higher-
39