Nexgrill 720-0536 Assembly & Operating Instructions page 32

Step 5: Remove Regulator
a. Use adjustable wrench to remove existing LP Gas regulator and Hose assembly.
b. If you are replacing an existing Natural Gas Grill, the supply hose that supplied
Natural Gas to the old Grill will work with your new Grill.
c. Replace the LP Gas regulator and hose assembly with a Natural Gas supply
hose and regulator (not supplied with the Grill). Follow installation instructions
as supplied by the manufacturer. The regulator might not be necessary. You
should contact the local Natural Gas company to determine if the gas pressure to
the property is Regulated (has a regulator in the system). If so then another
regulator is not necessary.
d. A new hose is not supplied with this Grill so as not to overcharge the consumer
for unnecessary parts.
Step 6: Check for Gas leak
Make sure you perform a leak test before operating the grill. Please refer to
Page 17 on the manual on how to test for gas leak.
Step 7: Adjustment of Control Valves for Main Burner, Side burner.
a Remove the black rubber ring on the control knob
b Remove all control-knobs with 5/32" Allen wrench (provided)
c. Adjust gas valve through access hole at knob-bezel by inserting a flat head
screw-driver. Turn the screw driver clockwise (to tighten) until it stops. (Not: it may
already be fully turned so it will not turn further). Then turn it counterclockwise (to
loosen) for one full revolution (360 deg, per revolution)
d. Adjust gas valves on the side burner.
e. Replace & secure knobs
Gas Conversion
Continued
32