Nexgrill 720-0536 Assembly & Operating Instructions page 22

TO LIGHT THE GRILL BURNER:
Make sure all knobs are "OFF" then turn on
the gas supply from the LP tank. Always keep
your face and body as far from the grill as
possible when lighting.
Your stainless steel grill has an exclusive
patented built-in ignition. The igniter is built in
to the valve. To ignite each burner simply
push and turn the control knobs to the HI
setting, you will hear the valve click as it
sends a spark to the pilot flame. If the burner
does not light wait 5 minutes for any excess
gas to dissipate and then retry.
WARNING: Always keep your face and body
as far away from the burner as possible when
lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any cooking
utensils from the burner grate. Push and turn
the control knob counterclockwise to the
"IGNITE/HI" position. If the burner does not
light, turn the control
knob to "OFF". If the smell of gas is detected
and the igniter is not functioning,
immediately turn the control knob "OFF".
Allow 5 minutes for any accumulated gas to
dissipate. If the side burner igniter is not
functioning, see the following section for
match lighting.
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts
then the burner can be match lit.
1. Locate match light extension rod
2. Use this device to match light your burners
Simply place a lighted match between the coils
on the end of the extension rod and hold next to
the burner to ignite.
Grill Lighting Instructions
If you've just attempted to light the burner
with the igniter, allow 5 minutes for any
accumulated gas to dissipate. Keep your face
and hands as far away from the grill as
possible. Insert a lit match attached to lighting
rod or lighter through the cooking grids to the
burner.(see next page) Press the control knob
and rotate left to the IGNITE/HI setting,
continue to press the knob until the burner
ignites. Burner should light immediately. If the
burner does not light in 4 seconds turn the
knob off, wait 5 minutes and try again.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match or lighter near the
side burner ports, turn the control knob
counterclockwise to "IGNITE/HI". Move your
hand immediately once the burner is lit.
Rotate the control knob to the desired
setting.
TO LIGHT THE OVEN BURNER:
Push the control knob & rotate it counter-
clockwise to the desired temperature. You will
hear click when turning the knob. This click
indicates that the igniter is turned on. Gas will
begin to flow & the burner will light when the
igniter has reached the proper temperature.
This process will take 35-50 seconds. When
turning the knob, you will notice the click & the
indicator light will be illuminated. This indicates
the igniter is turned on & the gas will start to
flow.
Keep a spray bottle of soapy water near
the gas supply valve and check the
connections before each use.
Do not attempt to light the grill if odor of
gas is present. Call for service 1-800-648-
5864
continued
22
22