Table of Contents
Advertisement
Basic Configuration
To configure the device via web browser, at least one properly-configured PC must be
connected to the LAN port (connected directly or through an external hub/switch to the LAN
port of the device). The configuration can also be performed on a wireless client station (as
Network 2 on Connection Figure 2).
On Ethernet Client
To access the Broadband Wireless Router (AP) via the Ethernet interface, the host computer
must install TCP/IP protocol:
Step 1
Choose a client PC and configure it to get a dynamic IP from the Broadband
Wireless Router (AP).
Step 2
Start up your browser and type 192.168.0.1 as the address to enter the web-based
manager.
Step 3
Enter the default username and password. Both values are admin (small letters).
Step 4
Go to Basic > WAN Setting to finish basic configuration. From the drop-down list
select your WAN connection type. Available options include: Bridge, Obtain an IP
address automatically, PPPoE and Specify an IP address.
According to the type you selected, different parameters will appear. After you
finish setting all the parameters, click Apply.
Note: You should contact your ISP for the correct connection type and its
corresponding configuration information.
Step 5
Perform the task of Save and Reset to have new settings take effect. When the
connection is established, the client PCs can access the Internet or remote network
through the Broadband Wireless Router (AP).
On Wireless Client
Step 1
Install the wireless card driver and verify the wireless setting is as below:
1. The default SSID: IEEE 802.11 LAN
2. WEP encryption is disabled. Authentication Type is Open Key (or Open
3. Use Infrastructure connection mode.
Step 2
Check that the TCP/IP protocol is installed on your wireless client PC. Configure it
to get a dynamic IP from the Broadband Wireless Router (AP).
Step 3
Enter the default username and password. Both values are admin (small letters).
Step 4
Go to Basic > WAN Setting to finish basic configuration. From the drop-down list
select your WAN connection type. Available options include: Bridge, Obtain an
IP address automatically, PPPoE and Specify an IP address.
According to the type you selected, different parameters will appear. After you
finish setting all the parameters, click Apply.
Note: You should contact your ISP for the correct connection type and its
corresponding configuration information.
12
System according to your Wireless LAN Card).
Advertisement
Table of Contents
