Drain System; Electrical Requirements - Maytag MVW18CS Installation Instructions Manual

DRAIN SYSTEM

Drain system can be installed using a floor drain, wall standpipe,
floor standpipe, or laundry tub. Select method you need.
Floor standpipe drain system
114 mm
(4,5") .
Minimum diameter for a standpipe drain: 51 mm (2"). Minimum
carry-away capacity: 38 L (10 gal.) per minute. Top of standpipe
must be at least 990 mm (39") high; install no higher than
2.44 m (96") from bottom of washer.
Wall standpipe drain system
114 mm
(4,5") .
See requirements for floor standpipe drain system.
8
990 mm
(39")
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number
285834). Minimum siphon break: 710 mm (28") from bottom
of washer. Additional hoses may be needed.
Laundry tub drain system
114 mm
(4,5") .
990 mm

ELECTRICAL REQUIREMENTS

A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric supply is
n
required. A time-delay fuse or circuit breaker is recommended. It
is recommended that a separate circuit serving only this appliance
be provided.
After installation, access to mains plug or disconnection from
n
mains supply via a double-pole switch, must be ensured at all
times in order to ensure immediate deactivation of the washer
in case of emergency.
This washer is equipped with a power supply cord having an
n
earthing plug. The plug should be accessible for disconnection
from the supply.
If the supply cord is damaged, it must be replaced by the
n
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
710 mm
(28")
(39")