Set Up The Router In Bridge Mode - NETGEAR R6400 User Manual

6. Select the Enable AP Mode check box.
7. Scroll down and select an IP address setting:
• Get dynamically from existing router. The other router on the network assigns an
IP address to this router while this router is in AP mode.
• Enable fixed IP settings on this device (not recommended). Use this setting if you
want to manually assign a specific IP address to this router while it is in AP mode.
Using this option effectively requires advanced network experience.
Note: To avoid interference with other routers or gateways in your network,
NETGEAR recommends that you use different wireless settings on
each router. You can also turn off the wireless radio on the other router
or gateway and use the R6400 router only for wireless client access.
8. Click the Apply button.
The IP address of the router changes, and you are disconnected.
9. To reconnect, close and restart your browser and type http://wwwrouterlogin.net.

Set Up the Router in Bridge Mode

You can use your router in bridge mode to connect multiple devices wirelessly at the faster
802.11ac speed. You need two routers: one set up as a router and the other set up as a
bridge.
Smart WiFi Router
Figure 12. Router in bridge mode with an 802.11ac WiFi connection
Installing your R6400 router as a bridge offers the following benefits:
AC1750 Smart WiFi Router
Smart WiFi Router in bridge mode
Specify Network Settings
129