Garage Door Openers; Programming To A Garage Door Opener With A Program/Learn Button - Chamberlain KLIK3U User Manual

gaRagE DOOR OPEnERs

Programming to a garage Door Opener with a Program/LEaRn Button

The Program/LeaRn button is typically located on the back or side panel of the garage door opener or an external receiver. For help
locating your Program/LeaRn button refer to the Help section in this manual or contact your garage door opener manufacturer.
If you have a Genie Intellicode
®
The images throughout this manual are for reference only and your product may look different.
1
Press the program button on the remote control until
the LED turns on.
LED
Program Button
3
Press and release the remote control button, the LED will
flash. When the LED stops flashing, continue to press and
release the button (maximum of 9 times) until your
garage door opener responds by clicking, blinking, or
activating.
5
Test the remote control by pressing the button. If the garage door opener does not activate, repeat the programming steps or
follow the alternative programming option.
2 garage door opener go to the next page.
®
2
P ress and release the Program/LEARN button* on your
garage door opener.
* D epending on your product, the Program/LEARN button may have a different
name (use the button for programming remote controls).
4
Press the program button on the remote control to save.
Program Button
8