Chamberlain KLIK3U-BK2, KLIK3U-BL2, KLIK3U-SS, KLIK3U-RT1, KLIK3U-RT2 - UNIVERSAL REMOTE CONTROL Manual

INTRODUCTION

The remote control can be programmed to activate up to two products, such as a garage door opener, gate operator, or commercial door operator. Each button on the remote control works independently of the other and must be programmed separately. The images throughout this manual are for reference only and your product may look different.

Read instructions thoroughly BEFORE beginning. If using the Universal Remote Control with residential door openers, the remote control must be used only with door openers manufactured after 1993 that utilize photoelectric sensors. The photoelectric sensors are always located on or near the bottom of the door track.

To prevent possible SERIOUS INJURY or DEATH from a moving gate or door:

• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.
• ALWAYS keep gate or door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.

This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

GETTING STARTED

Determine if the product you are programming the remote control to has a Program/LEARN button or DIP SWITCHES. The Program/LEARN button or DIP SWITCHES are located either on the product or in an external receiver on or near the product. The following instructions are for a garage door opener with a Program/LEARN button. For DIP SWITCH programming instructions or additional help please visit www.chamberlain.com/klik3.

PROGRAMMING

1. Remove the cover. Press and hold the program button until the LED turns on.
   
2. Press and release the Program/LEARN button on your garage door opener.
   
3. Select a button to program. Press and release the button the specified number of times according to the chart on the following page. Make sure the LED stops flashing between each press of the button. The garage door opener will respond by clicking, blinking, or activating.
   

   Garage Door Opener Brand	Type/Color of Program/ Learn button	Year	Number of times to press button
   Linear®	Mega-Code	'97-Current	1
   Chamberlain® *	Orange/Red	'97-'03	2
   Chamberlain® *	Purple	'05-Current	3
   Chamberlain® *	Green	'93-'96	4
   Genie® ** Overhead Door®	Intellicode	'05-Current	5
   Genie® Overhead Door®	Intellicode	'95-Current	6
   Stanley®	Secure Code	'98	7
   Chamberlain® *	Yellow	'11-Current	8
   Wayne Dalton®	Rolling Code	'99	9

   * NOTE: LiftMaster, Do-It, Master Mechanic, Raynor, True Value and Sears Craftsman are compatible with Chamberlain technology.
   ** NOTE: Visit www.chamberlain.com/klik3 for Genie Intellicode II instructions.
4. Press the program button on the remote control to save.
   

TEST

Test the remote control by pressing the button. If the garage door opener does not activate, repeat the programming steps or visit www.chamberlain.com/klik3 for additional instructions.

Need Help?
Go to www.chamberlain.com/klik3 ;
or call 1-800-442-1255