Chamberlain 950ESTD-P2 Instructions

For use with Security+ 2.0 ® Garage Door Openers which have a yellow LEARN button and yellow
antenna wire, and are manufactured after 2010. The code between the remote control and the
receiver changes with each use, randomly accessing over a billion new codes. Refer to your
With the door closed,
product manual for the location of the LEARN button.
press and hold
NOTE: the remote
Your product may look different than the products illustrated in this manual.
control button to
control the light.
WARNING: This product can expose you to chemicals including lead, which are known
to the State of California to cause cancer or birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov.
PROGRAM USING THE GARAGE DOOR OPENER

PROGRAM USING THE DOOR CONTROL

Press the LEARN button on
the door control to enter
Programming Mode.
With the door closed,
press and hold
the remote
The command LED
control button to
will flash once.
control the light.

TO ERASE ALL CODES FROM MEMORY

When deactivating any unwanted remote
control codes, all previous codes will be
erased. All additional accessories will
also be erased. Refer to your product
manual for more information.
steadily for 30 seconds.
Press and
hold the
+
LIGHT button
on the
LED
door control.
Locate the
LEARN button.
The LEARN LED will glow
steadily for 30 seconds.
With the door closed,
press and hold
Press the LEARN button again,
the remote
the LED will flash once.
control button to
control the light.
Press and
hold the
+
The command LED
LIGHT button
will flash once again.
on the
door control.
Within 30 seconds...
To prevent possible serious injury or death from a moving gate or garage door:
Press and
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate,
hold the
+
or play with remote controls.
LOCK button
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are
on the
no obstructions to door travel.
door control.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to
cross path of moving gate or door.
Locate the
LEARN button.
Press and hold the button
on the remote control.
Press and hold the LEARN button on garage door
opener or other product until the LEARN LED goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote control you
Press and
wish to use. immediately release
the LEARN button.
Within 30 seconds...
Press and Press and hold the button
hold the on the remote control.
+
LIGHT button
on the
door control.
Press and
hold the
+
LOCK button
on the
door control.
Press and hold the LEARN button on garage door
opener or other product until the LEARN LED goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote control you
wish to use.
REMOTE CONTROL
MODEL 950ESTD-P2
Press and hold the button
on the remote control.
Press and
Release the button
immediately release
when the garage
the LEARN button.
door opener lights
The LEARN LED will glow
blink or two clicks
steadily for 30 seconds.
are heard.
Within 30 seconds...
Press and
hold the Release the button when
+
the garage door opener
LOCK button
lights blink or two clicks
on the
are heard.
door control.
Press and hold the LEARN button on garage door
opener or other product until the LEARN LED goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote control you
wish to use.
After the garage
door opener
lights flash,
release all
buttons.
After the garage
door opener
lights flash,
release all
buttons.