Programming To Door Opener With Learn Button; Garage Door Openers - Chamberlain KLIK3U User Manual

GARAGE DOOR OPENERS

Programming to a Garage Door Opener with a LEARN Button
The LEARN button is typically located on the back or side panel of the garage door opener or an external receiver. For help
locating your LEARN button refer to the Help section in this manual or contact your garage door opener manufacturer.
®
If you have a Genie Intellicode
The images throughout this manual are for reference only and your product may look different.
1
Press the program button on the remote control until
the LED turns on.
LED
Program Button
3
Press and release the remote control button, the LED will
flash. When the LED stops flashing, continue to press and
release the button (maximum of 9 times) until your
garage door opener responds by clicking, blinking, or
activating.
5
Test the remote control by pressing the button. If the garage door opener does not activate, repeat the programming steps or
follow the alternative programming option.
®
2 garage door opener go to the next page.
2
Press and release the LEARN button* on your garage door
opener.
* Depending on your product, the LEARN button may have a different name (use
the button for programming remote controls).
4
Press the program button on the remote control to save.
Program Button
3